FAG 6024-M-C3 Deep Groove Ball Bearing - 120 mm ID, 180 mm OD, 28 mm Width Torque Tool synchronizers

synchronizers

The bell-shaped ball joint puller of series 128 is used to press out the ball studs when removing ball joints and tie rod ends on tie rods in automotive and industry applications

Compact handle/interchangeable blade system for fast blade change

Its precision-ground parallel faces ensure assembly squareness and straightness to the shaft

TORX PLUS® profile: in comparison to "normal" TORX® profiles

FAG 6024-M-C3 Deep Groove Ball Bearing - 120 mm ID, 180 mm OD, 28 mm Width Torque Tool synchronizersDeep Groove Ball Bearing FAG deep groove ball bearings are versatile, robust, and accommodate radial and axial loads in both directions. Their simple design, low friction, and high speed capability make them suitable for a wide range of industrial applications, from electric motors to gearboxes. Sealed and shielded variants protect against contamination, while open versions allow easy lubrication.